The cleats are some kind of Masonite and I redrilled mine to move the baffle retaining screws inward as some were very close to the edge of the baffle, which is a mdf material and sort of crumbly. Hello In this video I am taking out the electronics of my first ever purchased Vox Pathfinder 15R to give all the electrolytic capacitors a thorough checku.
Some PFs have a cleat across the bottom to attach the baffle, which will also need trimming away, but mine only had side and top cleats. The eye-catching looks of these 10-watt combos are also classic VOX and include basket-weave, leather-look, our distinctive diamond grille cloth and.
The hole ends up being flat on the top so you can stay below the gold front trim strip. I cut mine from the back side using a jig saw. You will have to remove a lot of staples so you can flip the bottom of the cloth out of the way. You remove that resistor and in it's place add an A50K pot to control the mids. I should have tested it a bit more thoroughly, but I'm noticing the reverb is seemingly non-existent, and all cranking it does is makes a hum (louder as you turn up the knob). Hi all, Just picked up one of these gems. The PF has a fixed resistor for the mids. Picked up a Vox Pathfinder 15R, reverb seemingly doesn't work, just adds hum.
#Vox pathfinder 15r repairs mods
As long as you do careful marking, you can cut the 10" hole leaving the grille cloth attached at the top of the baffle. Re: Vox Pathfinder 15R Mods by littlericky Fri 4:36 am. The Pathfinder 15R was a small solid state 1x8 15 watt combo amp that was. I had to remove the bell cover on the Weber. It is an easy mod, but you first want to check the depth of the speaker and diameter of the magnet do not foul the chassis. I did this as well, fitting first a WGS Veteran 10 and then a Weber Silver Ten alnico.
0 kommentar(er)
